Program
BASCOM AVRで開発の為、周波数のﾋﾟﾘｵﾄﾞ表示を簡単化する為、ﾒｶﾞ表示部分を3桁固定。その為、桁数に満たない場合、頭に0(ｾﾞﾛ)が付く。(3桁を超えると正しく表示されない。)ﾌﾟﾘｽｹｰﾗが1/128の為、ｹﾞｰﾄﾀｲﾑ1.28sec固定である。
ﾋｭｰｽﾞﾋﾞｯﾄもﾌﾟﾛｸﾞﾗﾑしてあるので、ｸﾛｯｸの設定に悩まなくて良い。
'********************************************************
'ATtiny2313 Frequency Counter
'
' 2016/02/01
' JA2GQP
' BASCOM AVR 2.0.7.5(DEMO version) Compiled
'--------------------------------------------------------
'Function
' 1.1/128 prescaler(resolution 100Hz,Gate time 1.28sec)
' 2.Display style 123.456.789MHz
'********************************************************
$regfile = "attiny2313.dat"
$crystal = 12800000
$prog &HFF , &HFF , &HDF , &HFF ' generated. Take care that the chip supports all fuse bytes.
'---LCD port assign ---
Config Lcdpin = Pin , Db7 = Portb.0 , Db6 = Portb.1
Config Lcdpin = Pin , Db5 = Portb.2 , Db4 = Portb.3
Config Lcdpin = Pin , E = Portb.4 , Rs = Portb.5
Config Lcd = 16 * 2
'--- Timer interrupt assign ---
Config Timer0 = Timer , Prescale = 1
Config Timer1 = Counter , Edge = Rising
'--- define memory ---
Dim Flag As Bit
Dim Over As Byte
Dim Tint As Word
Dim Freq As Long
Dim Str_frq As String * 12
Dim Dsp_frq As String * 12
'--- Initialization ---
Stop Timer0
Stop Timer1
On Timer0 Timer0_int
On Timer1 Timer1_int
Enable Interrupts
Enable Timer0
Enable Timer1
Cls : Cursor Off
Lcd "GQP F.Counter"
Locate 2 , 2
Start Timer0
Start Timer1
'--- Main proc ---
Do
If Flag = 1 Then
Freq = Over * 65536
Freq = Freq + Timer1
Freq = Freq * 100
Lcd " "
Locate 2 , 2
Str_frq = Str(freq)
Str_frq = Format(str_frq , "000.000000")
Dsp_frq = Left(str_frq , 4) + Mid(str_frq , 5 , 3) + "." + Mid(str_frq , 8 , 3)
Lcd Dsp_frq ; "MHz"
Flag = 0
Over = 0
Tint = 0
Timer1 = 0
Start Timer0
Start Timer1
End If
Loop
End
Timer0_int:
Incr Tint
If Tint = 64000 Then 'Gate time 1.28sec
Stop Timer0
Stop Timer1
Flag = 1
End If
Return
Timer1_int:
Incr Over
Return
